waterproofing chemical

I Need More Information

Our team will be in touch as soon as possible to discuss your needs.

Thank you for your message. It has been sent.
There was an error trying to send your message. Please try again later.

MS POLYMER

300% Elastic Waterproofing​

ISONEM MS POLYMER is a pure polymer produced using the latest technology and has excellent properties. It is ready to use, UV resistant, glossy, elastic structure waterproofing chemical. It is used as exterior insulation material on terraces, roofs, balconies, and wet areas, concrete, screed, plaster, wood, metal surfaces, spray polyurethane heat insulation applied surfaces. It is open to light pedestrian traffic and it has quick workmanship waterproofing chemical.

TECHNICAL SPECIFICATIONS

Density (25°C, g/mL) : 1,00 ± 0,10
pH (25°C) : 7.0 – 9.0
Viscosity (25°C, mPa.s) : 13000 – 15000
Solid content (% Weight) : 46 ± 2
Water transmission rate (kg/ m2. h0,5) : < 0,1 CLASS W3
Adhesion strength by pull-off test (N/mm2) : Crack bridging flexible systems without trafficking ≥ 0,8
Permeability to water vapour (m) : 5 ≤ SD ≤ 50 CLASS II
Solvent : Water

Documents of the ProductDOCUMENTS OF THE PRODUCT

CE CERTIFICATE
ISO CERTIFICATE
TSE CERTIFICATE

Color Scheme (Color Tones may vary due to resolution and light differences)

123-ОР-06-2020 The decision that the products are not subject to the requirements of the “Technical Regulation on Fire Safety Requirements”Certificate of State Registration of Products (SGR)

Insulation of terrace roofs and balconies
Facades
Roofs, woods
On old-based bitumen problematic insulation
On asphalt and concrete floors

Surface preparation: The floor must be strong, clean and resistant to load. All surfaces must be cleaned from oil, dirt and similar residues before application. In primer application, ISONEM MS Polymer is diluted with 200 % water (1 kg MS Polymer:2 kg water) and fed to the surface with a hard brush. The primer should be left to dry for at least 1 hour after application. In steel/metal surfaces, the surfaced should be primed with ISONEM Anti Rust Primer (Anticorrosive primer), consumption of 0,250 – 0,350 kg/m².

Application method: ISONEM MS POLYMER is ready to use. It is applied to the primed surface in two coats with a brush, roller or a suitable sprayer. Waiting time between the coats is at least 4 hours. The product is produced in two types as “winter” and “summer”. 18 – 40 °C for summer application, 5 – 17 °C for winter application.

Product consumption :
0,8 – 1 kg/m² (Color, two layers)
0,3 – 0,5 kg/m² (Transparent, two/three layers)
Paintable (Coverage) Area :
Color application
5 kg: 5 – 6 m²/bucket (two layers)
10 kg: 10 – 12 m²/bucket (two layers)
18 kg: 18 – 22 m²/bucket (two layers)
Transparent application
5 kg: 10 – 17 m²/bucket (two/three layers)
10 kg: 20 – 33 m²/bucket (two/three layers)
18 kg: 36 – 60 m²/bucket (two/three layers)

COLOR: All requested can be produced in colors.

SHELF LIFE: 24 months from date of production if stored in original, unopened, undamaged packages.

STORAGE CONDITIONS: Store tightly closed in a dry and cool place.