I Need More Information
DF9
ACRYLIC BASED WET ROOM WATERPROOFING,
it is an elastomeric resin based, solvent free, one component acrylic polymer based waterproofing material. It dries on the applied surface and forms a seamless, waterproof and elastic coating. The coating is resistant to high mechanical strength. Tile, ceramic and similar coating should be bonded with a suitable adhesive on the ISONEM DF 9 which high crack bridging capacity.
TECHNICAL SPECIFICATIONS
Density (25°C, g/mL) : 1,38 ± 0,10
pH (25°C) : 7.0 – 9.0
Viscosity (25°C, mPa.s) : 9000 – 12000
Solid content (% Weight) : 71 ± 2
Water transmission rate (kg/ m2. h0,5) : < 0,1 CLASS W3
Adhesion strength by pull-off test (N/mm2) : Crack bridging flexible systems without trafficking ≥ 0.8, with trafficking 1.5 N/mm²
Permeability to water vapour (m) : 5 ≤ SD ≤ 50 CLASS II
Solvent : Water
Documents of the ProductDOCUMENTS OF THE PRODUCT
CE CERTIFICATE
ISO CERTIFICATE
DF 9 TSE
123-ОР-06-2020 The decision that the products are not subject to the requirements of the “Technical Regulation on Fire Safety Requirements”Certificate of State Registration of Products (SGR)
TDS (EN) – ISONEM DF 9
SDS (EN) – ISONEM DF 9
· In wet volumes
· Bathroom-shower-restroom
· Terrace and balconies
· Can be used indoors and outdoors in any kitchen and similar wet areas
Surface preparation: Application surfaces should be dry and clean. Surface reparation and similar pre-insulation should be done before application. 45 g/m² insulation mesh should be used on wall and base joints. If there are residues prevent adherence like dust, dirt etc. on the application surface, they should be cleaned and the insulation and paint primer ISONEM UNIVERSAL PRIMER should be applied to the surface (1: 7 diluted with water;1 part primer, 7 parts water). The primer application should be after a minimum drying time of 4 hours.
Application method: ISONEM DF 9 is ready to use but must be mixed well before use. ISONEM DF 9 is applied by brush in two layers without dilution waiting 4 hours between coats. The insulation application should be protected from water for 24 hours. Do not apply below + 5°C or wet and frozen floors.
COLOR: Blue, white or grey.
CONSUMPTION: 1 kg/m² (two layers application)
1 kg/m² (two layers application)
5 kg: min. 5 m²/bucket (two layers)
18 kg: min. 18 m²/bucket (two layers)
PACKING: 5 kg and 18 kg PP buckets
SHELF LIFE: 24 months from date of production if stored in original, unopened, undamaged packages.
STORAGE CONDITIONS: Store tightly closed in a dry and cool place.
