Surface preparation: Before the application, surface cleaning and primer application should be done. The application surface should be free from all kinds of oil, dirt, dust, and surface wastes. If necessary, surface cleaners should be used in order to clean the surface from all grease and dirt, and after the cleaning process, the surface should be cleaned from these cleaners and dirt with water. When it is sure the surface is completely cleaned and completely dry, primer application should be started. Concrete, marble, granite, raw wood, tiles, ceramics, and all similar surfaces should be primed with ISONEM EP Primer, an epoxy-based solvent-free primer with consumption of 0.250 – 0.400 kg / m².
Mixture preparation: ISONEM COUNTERTOP PAINT is supplied in ready-to-use sets according to the mixing ratio. The mixture should be prepared in the amount to be applied, paying attention to the mixture life. Before starting the mixture, make sure that the material temperatures are between 15 and 25 ° C. Component A should be mixed with a suitable mixer for 3 – 4 minutes without entraining air. Next, the entire B component should be poured into the A component and make sure that no material is left in the B component. A + B should be mixed for at least 3 minutes until a homogeneous mixture is obtained and the prepared mixture should be consumed within 30 – 40 minutes.
Application method: The mixture should be applied on the prepared surface with the help of a brush or roller. If thickness is desired, the second layer should be applied after the surface of the first layer has dried. Hard drying time reaches 18 – 24 hours. It passes full hardening and physical and chemical resistance in 7 days.